Doepfer A-138b

73

Doepfer A-138b Mixer met Logaritmische Potentiometers

  • Voornamelijk geschikt voor audiosignalen
  • Breedte: 8 TE / HP
  • Diepte: 35 mm
  • Stroomvereisten: +10 mA (+12 V) / -10 mA (-12 V)
Leverbaar sinds Januari 2004
artikelnummer 166482
verkoopseenheid 1 stuk
Modul Type Mono
Width 8 TE / HP
€ 54
Incl. btw plus € 5,90 verzending
direct leverbaar
direct leverbaar

Dit product is op voorraad en kan direct verzonden worden.

Informatie over de verzending
Levering ongeveer tussen Woensdag, 3.04. en Donderdag, 4.04.
1

73 Klantenbeoordelingen

4.7 / 5

U moet ingelogd zijn om producten te evalueren.

Note: Om te voorkomen dat evaluaties gebaseerd zijn op roddel, geruchten of heimelijke advertentie staan wij op onze website alleen evaluaties toe van daadwerkelijke gebruikers die het geevalueerde product bij ons gekocht hebben.

Na inloggen vindt u alle producten die u kunt evalueren ook onder “Product evalueren” in uw klantencentrum.

bediening

features

afwerking

28 Recensies

S
standaard module
Spraypainter 18.11.2020
simpele module met duidelijke lay-out die prima werkt en goed klinkt.
Geluiden samen voegen is het hoofddoel, maar kan ook in feedback patches gebruikt worden.
bediening
features
afwerking
0
0
Evaluatie melden

Evaluatie melden

D
Perfect!
Dennis010 21.06.2017
Zowel prijs als kwaliteit is deze module TOP.
Ik zou geen andere aanraden, geluid is goed, knoppen lekker groot en afwerking ook perfect.
Maarja dit is eigenlijk wat we van Doepfer gewend zijn.
0
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
B
Doepfer A-138-B Mixer
Blair 18.11.2013
The A-138b is essentially a 4 into 1 mixer optimised for audio signals rather than control voltages. the 'b' in the name means the the mixer uses logarithmic rather than linear potentiometers.

For me the A-138b is an essential piece of equipment because it enables me to sum the outputs of up to 4 sound sources (for instance VCO's or noise sources) before sending the combined output to my A-108 Low pass filter module.

With one input employed, and with the channel and master levels set to 10, the volume of the output is the same level as the input signal. in other words, this module will not increase the gain of an input, it will only attenuate it.

When using multiple inputs I find I have to reduce the levels of the individual channels quite a lot, otherwise the output from the mixer becomes to much for next module in the chain. So if I am using 3 inputs, I will use a maximum of about 33% of each channel's volume.

The mixer appears to operate very quietly. It does not introduce much 'hiss' into the sound. Some reviewers have found otherwise , so it may be that my ears are not as sensitive as theirs.

I have rated the A-138b as 5 stars except for features, which I have given a 4 for. The reason for this is that the Doepfer website indicates that with no input into channel 1, the channel 1 level will act as a +5 volt DC offset. In other words, the unit *can* increase the level beyond that of an input signal. However, my unit doesn't work like this. As delivered, all 4 inputs on my A-138b work in the same way. The manual says there is a jumper I need to re-position on the rear of the circuit board to achieve the +5 volt DD offset with input level 1. I think this option should have been made available as a toggle switch on the front panel. It would be useful on occasions when I am only using 3 inputs, but I do not want to have to remove the unit from its case and re-position a jumper each time to achieve this!

Overall, another useful and great value unit from Doepfer, in my opinion.
3
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
M
MiguelDF 06.11.2017
I bought this item to use as a mixer for my Doepfer modules, I own 3 more modules and in order to be able to send only one output from my 3 modules I found out this mixer. I was not able to find any disadvantage for this item, the knobs have a good sensitivity, both inputs and outputs work just fine, and it is possible to connect this mixer to the main power suply.
For a low number of outputs, as the ones I have this is a great choice for these systems, for biger systems maybe other options should be considered.
So, all in all, I definitely recomend this item to incorporate in a Doepfer based system
1
0
Evaluatie melden

Evaluatie melden