Adam Hall 019740 Pre-Cut Foam

89

Raster foam

  • Dikte: 40 mm
  • Polyester met 15 mm raster afdrukbaar
  • Plaat grootte: 142 x 33 cm
Leverbaar sinds Oktober 2010
artikelnummer 253227
verkoopseenheid 1 stuk
Type Inlay
€ 29
Incl. btw plus € 4,80 verzending
direct leverbaar
direct leverbaar

Dit product is op voorraad en kan onmiddellijk verzonden worden.

Informatie over de verzending
Levering ongeveer tussen Donderdag, 11.08. en Vrijdag, 12.08.
1

89 Klantenbeoordelingen

23 Recensies

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
JT
A bit tricky to install
Josef T. 263 30.06.2014
I wanted to use this to my gig-case where the line box, strings and all other necessary stuff is kept to keep everything it it's place when moving it around. I managed to cut pieces for placing the stuff but probably i should have used a sharper knife, cause it wasn't easy to cut it so it looked good afterwards...
2
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
N
Handy
NyquistAudio 24.04.2018
Super handy, great quality pluck and go foam to fill out a case or drawer to protect your microphones. I used it in a drawer to keep our 2 x Sennheiser Handheld Transmitters and 2 x Sennheiser beltpacks with Countryman E6 protected. Couple years of use later and it's still in good condition.
stabiliteit
hanteerbaarheid
afwerking
0
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
B
Great product
Ben518 15.05.2013
A very good product, and bigger than I expected, the foam is very soft which might not be ideal in all cases.
1
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
A
Brilliant!
Anoniem 07.06.2014
I was looking for a foam to protect some gear in a hard-case and the quality of this foam and the amount you get in one sheet left me with no complaints. I have since used the same foam to protect optics for my telescope and it has served me well so far.

The 'perforated' construction made the shaping process a whole lot easier than I had anticipated. I used a small scissors to create the shapes I needed, though you could just tear along the perforations without making a mess of it.

When I need more foam in future I'm not even going to shop around, I'll head straight for this product again and again.
stabiliteit
hanteerbaarheid
afwerking
0
0
Evaluatie melden

Evaluatie melden