RME ADI-2 DAC FS

96

High-End DA Converter & Headphone Amplifier with ESS chip (from June 2021)

  • Sample rates: 44.1 kHz up to 768 kHz
  • High-resolution playback of PCM, DXD and DSD at up to 768 kHz
  • SteadyClock FS
  • LCD
  • AutoDark function for lighting
  • Signal-to-noise ratio (SNR) @ +7/+13/+19 dBu: 120 dB RMS
  • Unweighted, 123 dBA
  • IEM output with -120 dBu
  • Class compliant mode
  • Extended Remote Control (buttons for Standby On/Off, adjustment of volume, balance, bass and treble, input selection (optical, coaxial, USB), mute, on/off switching of loudness, bass/treble and EQ)
  • SPDIF input signal can be recorded via USB
  • 4-Stage hardware output level adjustment
  • Desktop case
  • Dimensions: 215 x 52 x 150 mm
  • Weight: 1.0 kg
  • Incl. MRC remote control, USB cable and power supply unit

Connections:

  • 1x S/PDIF input coaxial
  • 1x ADAT or S/PDIF input optical
  • 2x Line output RCA unbalanced (stereo L/R)
  • 2x Line output XLR balanced (stereo L/R)
  • Extreme power stereo headphone output 6.3 mm Jack
  • Super Low Noise IEM output 3.5 mm mini jack
  • USB 2.0 port (USB 3.0 compatible)
In catalogo dal Novembre 2019
Numero di articolo 478603
Unitá incluse 1 Pezzo
Amount Of Channels 2
AD Conversion No
DA Conversion Yes
Max. Resolution 32 bit
Max. sampling rate 768 kHz
S/PDIF Connecor Yes
AES/EBU Connector No
ADAT Yes
Word clock No
Number of analog inputs 0
Number of Analog Outputs 4
Headphone connection Yes
Number of stereo channels 1
Output Level Adjustment Per Channel 1
Amount Of Inputs 2
Special Features Conversion from DSD and Direct DSD, SteadyClock FS, LCD-Display, incl. Remote
Mostra altri
€ 1.099
Spedizione gratuita, incl. IVA
disponibile
disponibile

Questo articolo è disponibile in magazino e può essere spedito a breve.

Informazioni sulla spedizione
1

96 Valutazioni dei clienti

78 Recensioni

I
Grande suono, ottima versatilità, un solo difetto...
Illbegood 01.10.2019
Dopo aver provato diversi concorrenti nella fascia fino ai 2500 euro e alla fine ho deciso di tenere l'ADI-2 DAC FS. Lo utilizzo come convertitore connesso all'ingresso linea di un Beyerdynamic A2 per l'ascolto in cuffia. Non segue nessuna moda, ha un solo convertitore e neppure dell'ultima generazione, eppure suona molto più naturale e dettagliato di molti suoi concorrenti che hanno una impostazione più "audiofila" ovvero meno naturale e che tende a dare troppo calore al suono. L'ADI-2 DAC è neutro, non aggiunge e non toglie nulla, è la dimostrazione di come chi sa progettare badando alla sostenza, non ha bisogno di utilizzare 10 convertitori, alimentazioni troppo sofisticate o tecnologie proprietarie ma riesce, con pochi mezzi, a tirar fuori un grande suono. Inoltre è un eccellente amplificatore per cuffie, non ha la raffinatezza, la piacevolezza e nemmeno il dettaglio del mio A2, ma è comunque molto silenzioso e neutro ed è in grado di pilotare anche cuffie ad alta impedenza e/o che richiedono tanta energia.
Costruzione quasi impeccabile, sarebbe stata perfetta se non fosse per i piedini che non hanno sufficiente attrito e su alcune superfici, premendo le manopole o anche solo inserendo un jack, il dispositivo si muove.
Difetti? Si, uno solo ma abbastanza importante secondo me, non è compatibile con dispositivi Android ma solo iOS, però se non avete l'esigenza di connettere un dispositivo Android via USB non è un problema.
Non commento la parte forse per alcuni più interessante ovvero le funzioni di elaborazione del suono quali equalizzazioni, loudness e quant'altro perché io lo uso sempre e solo flat, l'ho scelto solo per il suono che trovo, in questa fascia prezzo e fino ai 2000 euro, insuperabile e migliore di molti suoi concorrenti anche più
famosi e blasonati.
uso
Caratteristiche
Qualità
Suono
4
0
Segnala un abuso

Segnala un abuso

v
Ottimo prodotto
vissiv 09.05.2020
Per l'ascolto in cuffia che riguarda il mio caso, l'equalizzatore parametrico per me è insostituibile. Consente di correggere senza problemi eventuali idiosincrasie nei confronti di picchi indesiderati. In questo modo quasi ogni cuffia può essere adattata alle proprie aspettative.
uso
Caratteristiche
Qualità
Suono
0
0
Segnala un abuso

Segnala un abuso

google translate gb
Sfortunatamente si è verificato un errore, La preghiamo di riprovare più tardi.
m
Best thousand euros you will ever spend on audio gear
musicinprag 02.12.2019
I agree with most of what Artemis *Seven* wrote in his review. I have some Sennheiser HD 25s which I leave on my desk because they're tough and cheap and I don't have to baby them. They're a little bright but resolve pretty well so I keep them handy for monitoring recordings on some of my TASCAM gear. Other times I run them out of a Chord Mojo I have connected to a Linux box.

Last night I played some high rate PCM sample files and SACD rips over the RME and I couldn't believe what I was hearing. This DAC is beyond superb. It turned the HD 25s into a high end listening experience. The headphones absolutely disappeared and I was there in the concert hall. Just fantastic. I don't remember a wow moment like this. And I could not have expected it from this pair of headphones.

RME has a forum and there is a good chance that bugs in the firmware will be addressed. The device speaks for itself as soon as you listen to it.

The DAC comes with a real dead-tree manual, spiral bound and lay-flat so you can linger over it and you will need to! However the manual comes with a note saying it's somewhat out of date. I think it should have gotten the latest manual.

The RME does not seem to be a good pairing for my Sennheiser HD 600s but I'm not really surprised since the 600s are usually much happier on tubes. This is not a complaint about the RME, just to let anybody know that if Sennheisers are your main phones like they are for me, you might want a separate headamp to drive off the RME. I have several here but have not had the time to experiment.

I have not tried to run the RME into a hifi system but from what I have heard on phones I believe it would be difficult to beat. For now it is used as a DACAMP on my desk. The lights-out mode is neat but that is only an option when the device is on. When it's off there is a bright red ring around the power button. There should be an option to turn that off completely.

There are tons and tons of features and settings and I find navigation a little confusing. Three controls rotate and can also be pushed and their behavior depends somewhat on where you are. UI is hard. This is good but quirky. You won't be bored...

I still can't figure out how to deal with the EQ but to be honest I haven't spent much time with the manual.

The DAC has protective features so it won't burn up a pair of expensive IEMs or blow up your ears. A lot of thought went into the details on this. I'm impressed with that, it is somewhat unique. But I too would have preferred 2 x 1/4 inch headphone jacks rather than one for headphones and one for IEMs.

One ongoing annoyance is that the device is really light and the feet don't grip. It slides all over the place when pushing buttons, plugging and unplugging headphones etc. If it weren't so hugely musical and so hugely customizable it would be easy to think it was junk. I'd still like some real traction on a table top but this piece of gear is definitely staying around and no plans to ever sell it.
uso
Caratteristiche
Qualità
Suono
6
0
Segnala un abuso

Segnala un abuso

google translate gb
Sfortunatamente si è verificato un errore, La preghiamo di riprovare più tardi.
K
AudioVoodo killer
Karister 05.07.2020
I’ve been looking for a DAC to my Stereo system and DAC+AMP for my headphones for quite a while. Finally I picked RME ADI-2 ADC FS due to it’s awesome measured performance, decent power output for headphones and advanced DSP.

I owned a few devices (Marantz HD-DAC 1. Matrix Audio Element M, Burson Conductor, Schiit Audio) before and RME is the first one that after two weeks I have nothing to complain about. It is simply an audio-voodoo nonsense killer.

Firstly it has a brilliant noise floor. My sensitive IEMs are dead silent when nothing is playing. Finally! Secondly it can easily drive my HiFiMAN Arya which is a demanding headphone. No hassle at all. While low power mode is not enough for loud listening, high power mode shows it’s true potential. Even when close to max volume (sorry to my ears for that) there was no distortion at all. My HiFiMAN Arya was shaking on my head due to intense drivers’ movement and in a sub-bass heavy song it sounded no worse than a stereo system with a proper subwoofer. While my previous amp (rated at 1W per channel) was just producing one big distortion, sound from RME was perfectly clean and powerful. In terms of sound quality and performance I simply love it.

Second thing that I love is that it cured me from audio-voodoo. Detailed DACs, Warm sounding AMP, silver cables… come on. RME’s parametric EQ offers way more versatility. It really allows you to fit sound to your personal taste. I would love it to have more than 5 bands, though. Nevertheless, it is still a powerful tool. Another great function is crossfeed. Must have for headphones listening. I hate it when one instrument plays to the left ear and another one to the right ear. It is such an unnatural and tiring feeling. Crossfeed fixes it. While instruments stay in their positions, this unpleasant feeling is gone and instruments are more to the center. Something like listening to the stereo system which is always in front of the listener. Another nice thing is that RME saves settings for each output separately. This way I can have separate volume and EQ settings for stereo and headphones. I need to only switch the output and all settings are loaded automatically. It is simply clever and well thought.

There are some other minor cool things worth mentioning as well. Four programmable buttons in the remote are very handy. Auto input select works great. I connected my PC via optical and my network player via coax. Thanks to it, RME normally works as a DAC for PC but when I start playback via network, it automatically switches to coax input. When I stop playback from the network, it automatically goes back to optical. So convenient! Just perfect.

There are only minor things that I dislike about RME ADI-2 DAC FS. Firstly, It’s weight. It is too light and it must be held when pressing encoder knobs. Fingers easily leave greasy marks on it. Secondly, I use it as a DAC for stereo and DAC+AMP for headphones as mentioned before. I set volume for line out to 0dB as I have volume control in my stereo AMP. When I change Mute line setting from Toggle Ph/Line (it allows me to switch between Headphones and line out with the remote) to Off, RME switches output to headphones and uses volume setting from line out. 0dB in my case. This could be an unfortunate death of many headphones and ears due to misclick when done during playback. Lastly, I would appreciate some protection film for display. Mine was unprotected during shipping.

Last big plus for RME for their guide movies on Youtube. Very detailed and helpful. Despite being loaded with an enormous number of functions, I managed to set everything up without opening the manual.

To sum up - my best audio purchase ever. Price is very competitive when compared to hi-end audiophile companies. I am pretty sure I will be RME fanboy for a long time.
uso
Caratteristiche
Qualità
Suono
6
2
Segnala un abuso

Segnala un abuso

Adatto a YouTube