K&M 238 Mikrofon Support Rail

I use these for a weird purpose...

I use special dynamic mics with a higher frequency range to record my cymbals (odd but listen) I do this as a means of reducing the spill what you get from condensors. I them use some processing to enhance the top end in the mixing stage. This means I get more clarity from the kit and eliminates a lot of the mid range masking other things in the mix such as guitars, vocals and snares. I can them apply reverb to an appropriate amount (which is great if you don't have an ideal sounding room)

These save me a lot of time! I don't have to use mic stands now (which is amazing) and saves sooo much time. They're built very well and can take a beating! HOWEVER you cannot adjust the length of the clips (which is obvious) but is a bit of a flaw. Anything else to do this kind of job requires a lot more money though and I think these are great. A little expensive for what they are but I think they'll last a long time.

Does exactly what you need it to do. The mic clip goes on one end and then the other can be attached to their other mic stands or to other types of stand like cymbal stands. I bought two and use one for the bottom mic on a snare drum (attached the the mic stand for the top mic on the same drum) and the other attached directly to the stand of a ride cymbal, directly underneath. Perfect for both jobs. Cheap, but reliable and means you can keep a tidier stage set up by minimising the number of stand needed. Perfect!