Sommer Cable Stage 22 SG0E-0500-SW

49

Câble micro de 5m

  • Longueur: 5 m
  • Fiches noires Neutrick NC3-BAG
  • XLR femelle coudée (NC3FRX-BAG) > XLR mâle droit (NC3MXX-BAG)
  • Câble micro Sommer Cable Stage 22
  • Section de câble: 2 x 0,22 mm²
  • Gaine PVC, diamètre: 6,4 mm
  • Couleur: noir
Référencé depuis Juillet 2014
Numéro d'article 344617
Conditionnement (UVC) 1 Pièce(s)
Couleur Noir
Longueur 5,00 m
De la connectique XLR 3 broches coudée femelle
Vers la connectique XLR 3 broches mâle
28 €
TVA incl. ; Supplément de 5,90 € pour l´envoi
Disponible immédiatement
Disponible immédiatement

Cet article est disponible en stock et peut être envoyé immédiatement.

Informations sur l'expédition
Expédition estimée le Jeudi, 25.04.
1

49 Évaluations des clients

5 / 5

Vous devez être connecté afin de pouvoir évaluer un produit.

Note: Afin d’éviter que les évaluations de notre site soient polluées par des “ouï.dire”, des approximations ou encore de la publicité clandestine, nous autorisons uniquement nos clients à évaluer les produits achetés chez nous.

Une fois connecté, vous trouverez dans votre compte client, via le lien "Évaluer des produits", tous les articles que vous pouvez évaluer.

Qualité de fabrication

25 Commentaires

J
super câble micro (batteur)
JoGail 11.11.2021
J'ai acheté ce câble pour le micro chant batteur.
la fiche coudée permet de gagner un peu de place.
j'envisage d'en prendre 5 autres pour les Overheads et les micro Tom, plus pour des raisons esthétiques aussi.
très bonne qualité de câble.
je recommande !
Qualité de fabrication
0
0
Signaler l'évaluation

Signaler l'évaluation

KM
right angle cable
King MOt 04.06.2023
I didn't think about the orientation of the pins when I ordered it. When I connected them to my Yamaha MG12XU mixer, the cables draped across the mixer board and covered the stereo out jacks, the phones jack and the footswitch jack. I had thought the cable would just go backwards off the mixer. Problem. In the end, I conducted surgery (without anesthesia for myself). After opening the female end of the cable, I was able to reorient the connector, rotate part of the assembly and using a Dremel tool and a cut off wheel grind a notch in the aluminum which allowed the cover to slide back into place properly and fully. Not fun, not fast, dangerous and of course I wore eye protection. Success. Now the cable connected to the right output (I didn't need to operate with the Dremel tool on that one but I did have to open up and reorient the connector) comes off at a right angle to the mixer and doesn't cover up any other jacks. After the Dremel surgery, the cable on the left output comes off the mixer on an angle still but doesn't cover up any other jacks. So problem solved. Not a surgery for the weak of heart.
Qualité de fabrication
0
0
Signaler l'évaluation

Signaler l'évaluation

D
super qualité !
DCoil 04.07.2022
J'ai acheté ces câbles afin de connecter des micros en couple ORTF ou autre, et éviter qu'ils ne se touchent. ça fonctionne très bien avec un pied très haut ; je raccorde ensuite un autre câble jusqu'à l'enregistreur.
Très bon câble et excellents connecteurs, discrets en plus.
Je referais ce choix.
Qualité de fabrication
0
0
Signaler l'évaluation

Signaler l'évaluation

F
Parfait
Fantom 22.10.2019
En sortie de ma mixette sur des Yamaha HS8.
Qualité de fabrication
0
0
Signaler l'évaluation

Signaler l'évaluation