the box Replacement Speaker MBA120W

2

Replacement Speaker

  • For MBA120W and MBA120W MKII
  • Size: 10"
  • Impedance: 4 Ohm
Myynnissä vuodesta Toukokuu 2016
Tuotenumero 389134
Myyntierä 1 kappaletta
Impedance 4 Ohms
Load Capacity 120 W
66 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Saatavilla 1-2 viikon sisällä
Saatavilla 1-2 viikon sisällä

Tuotetta saatavilla pian varastoon ja lähetykseen.

Tietoa lähetyksestä
1

2 Asiakkaiden arviot

4.5 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Ääni

Työnjälki

2 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
PR
10" 4-ohm speaker.
Peter R. 438 06.07.2016
I got this to replace a suspect 4-ohm co-axial speaker/horn in an acoustic combo.

The original speaker was 10" too, but was a bit "grindy/mushy" above 1/2 volume, I suspected the horn for this problem after wiring into a PA speaker instead.

I fitted the new speaker & got another 1/4 turn on the volume before the "grindy/mushy" problem reappears. There is some AC smoothing problems on the amplifier circuit board, but I can use almost full volume now & the extra db (sound) this speaker punches out is great. The lack of a horn helps smooth the sound too.

This speaker comes on song, sounding good at 100 hz and holds a good sound till around 3 - 4 Khz, 5 - 10khz is only for dogs and cats to hear. The new speaker is a little bigger in physical size & weight than my original 10" speaker, mounting holes are the same though.
Well worth the work for its stronger & cleaner sound.
Ääni
Työnjälki
0
2
Raportoi ongelmasta

Raportoi ongelmasta

google translate de
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
Tuntematon 03.08.2016
Dieser Speaker wurde von mir als Ersatz eines defekten
Lautsprechers in einer aktiven "Plastik-Box" eingesetzt.
Meine Auswahlkriterien waren: mechanisch sollte er passen, relativ leicht sein, guter Wirkungsgrad und 4 Ohm.
Aus der Artikelbeschreibung ging schon viel hervor, dass der Wirkungsgrad ordentlich sein wird erhoffte ich mir, da dieser ja für eine Akkubox vorgesehen war, wo mit relativ niedriger Verstärkerleistung gearbeitet wird.
Alle meine Erwartungen wurden erfüllt. Übrigens ist es ein italienisches Produkt, welches einen sehr soliden Eindruck macht.
Ääni
Työnjälki
2
0
Raportoi ongelmasta

Raportoi ongelmasta