Stairville LEDBNC Gooseneck Lamp

608

LED Gooseneck Lamp

  • With 4 LEDs and BNC plug
  • High quality
  • Length of gooseneck: 26 cm
  • Total length: 34 cm
  • Voltage: 12 Volt
  • Current: 50 mA
  • Inner pin polarity +
  • Outer pin polarity -

Note: This article does not work with Behringer LC2412 - Article Nr 161602

Myynnissä vuodesta Elokuu 2005
Tuotenumero 180233
Myyntierä 1 kappaletta
Connector Type BNC
Right Angle Plug No
LED Yes
Length 26 cm
18,60 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tämä tuote on varastossa ja voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Perjantai, 27.05. - Maanantai, 30.05.
1
PK
Stairville LED joutsenkaula
Pauli K. 19.10.2015
Toimii hienosti oman Soundcraft Si Expression 1 -mikserin kanssa. Valaisee tasaisesti koko tiskin ja valoteho riittää hienosti. Myös kaulan pituus on sopiva, jotta lampun saa tarpeeksi ylös.
Valoteho
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

b
Flickering issues
buddycop 24.07.2018
Tried using this with Furman PL-8 CE, but it has some odd flickering issues. Now I'm not a gooseneck lamp expert but it feels as if the voltage or amperage doesn't match between these two products. Still, I'm using the lamp only for a few seconds at a time to help me connect some cables, thus I can live with the problem.
Valoteho
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

T
Longlasting leds, not
Tremolopää 30.09.2020
After a year one, one led gone and second strarted to flashing, annoying.
Maybe got to break that flashing led, think its causing some mental issues when pointed on the mixer.
Valoteho
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
S
Bright Light - Bright Light
Simoof 07.09.2015
Pardon my quote from gremlins.

This is a nice little bright light, it does spill a lot of light out abd can be positioned easily over any part of my 16 channel desk.

There is no on off switch so once connected its on. However, the lighty bit can disconnect from the neck easily so this is an option if you want to go back to darkness.

I have only used it a few times, but so far it stays exactly where i move it to, and the light is bright enough for me to read the area directly below it, I do need to move it up and down whilst looking up and down the channel mixer as the light is not quite enough to reveal all my desks dark little secrets. But then again, if it did, I would be very distracting to the band.
Valoteho
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta