Mooer Table Adapter EU

98

Power Supply for Effect Devices

  • Version with Euro plug
  • 9 V DC
  • 2000 mA
  • Output connection: 5.5 / 2.1 - 2.3 mm
  • Positive pole outside
Myynnissä vuodesta Helmikuu 2014
Tuotenumero 334950
Myyntierä 1 kappaletta
DC/AC current DC
Output current in mA 2000 mA
9 V Yes
12 V No
18 V No
Secondary voltage No
Multi-output power supply No
22 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Torstai, 2.05. - Perjantai, 3.05.
1

98 Asiakkaiden arviot

4.7 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

48 Arvostelut

m
Järkevän hintainen laadukas virtalähde
munis 09.07.2020
Sopii hyvin jatkojohtoihin ja muualle, missä voi olla muiden muuntajien tms takia vähän ahdasta. Ei surise, pörise eikä muutenkaan häiritse vaan tekee työnsä vikisemättä ja pitää bändikaveritkin tyytyväisenä. Antaa riittävästi virtaa useammallekin pedaalille esim Harley Benton PowerPlant Tunerin avulla!
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

K
Enough juice for HX stomp (remember to buy an cable plug adapter!)
Kasper92 29.08.2022
Thomann staff recommended this as a substitute power supply for a HX Stomp pedal. The original one broke in a few months, this one feels a bit sturdier. Cable is quite long, for me that is a positive (I use cable strap for the excess). You also need this plug adapter: Rockboard Power Ace Conl6. This combo is cheaper than the line 6 offering.

Thank you for good service!
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
Good value for money
Tuntematon 21.05.2014
The table adapter has a steady, regulated output that allows for pedals to be daisy-chained without too much of a risk of noise and hum. However, it is not as stable and noise-free as a power supply with multiple outputs. The unit I received generated (or captured?) interference noises that would affect the signal chain even when not connected to the pedals. (Although it's quite possible that the unit I received was defective and not all Mooer Table adapters are noisy?) However, as with all things Mooer, size and price are a plus factor. I have chosen to keep this unit as a reserve. It fits nicely under my pedal board like a spare tire!
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
It does its job
Tuntematon 20.10.2016
I use it to power up my Mooer Blade pedal and I am planing to use a daisy-chain to power 4 more Mooer pedals.Until now it works good and its wires are pretty long.No hum sound so everything is good.
No cons.
Työnjälki
0
1
Raportoi ongelmasta

Raportoi ongelmasta