Millenium SG-1

75

Signal Generator

  • With the built-in 1 Watt amplifier this device is ideal for (8 Ohm) speaker tests
  • Line output for active speaker or mixer tests
  • Tunable frequency between 20 Hz and 20 kHz
  • Power supply with 9V block battery
  • Output switchable between XLR line or speaker twist for the speaker test
  • Dimensions: 110 x 72 x 40 mm
Myynnissä vuodesta Helmikuu 2014
Tuotenumero 326025
Myyntierä 1 kappaletta
Cable Tester No
Level Meter No
Speaker Tester No
Software No
39 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Torstai, 2.05. - Perjantai, 3.05.
1

75 Asiakkaiden arviot

4.4 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Ominaisuudet

Työnjälki

40 Arvostelut

B
Boblander 24.05.2018
Very useful signal tester. When you have a kit of XLR-adapters available, you can test basically any sound gear.

Only small bad thing is that PSU option would be nice, when you don't have a spare 9v battery available.

Also I have to note that this isn't a precise instrument, when controlling a 20Hz - 20kHz range with a single pot. If you need that precision, look elsewhere.
Työnjälki
Ominaisuudet
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
PR
Great little gadget.
Peter R. 438 27.07.2015
Test all your speakers/ horns "full range" and even amps/desks/cables/etc, this little thing even helps setting up sound at gigs.

Mine had problems when it arrived, didn't work at all, the screws holding the belt clip were too long, pushing against the circuit board inside, earthing the signal, I just guessed this and removed the screws, hey presto!

I found a faulty horn in one of my PA speakers simply by plugging in and listening, BUT DO BE CAREFUL WITH YOUR EARS, one watt is enough to blow your ears as you listen closely or even not so closely, please be careful.

There's far more expensive ones but why pay more.
Työnjälki
Ominaisuudet
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
j
Very Handy Tool For The Sound Kit
jordan-uk-sound 08.08.2017
I bought this to add to my tools in my sound kit, I was hesitant to purchase because of the price but I decided to bite the bullet and I am glad I did it's been incredibly helpful when troubleshooting a sound system or repairing speakers if you aren't near a desk.

Very happy would recommend.
Työnjälki
Ominaisuudet
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
Handy, particularly for speaker testing
Mark8610 04.08.2022
As the output level and frequency are uncalibrated this is not for precision testing. It is however a handy tone source for continuity testing, and the loudspeaker output is useful for confidence testing of driver and crossover testing in multi way systems.
Työnjälki
Ominaisuudet
0
0
Raportoi ongelmasta

Raportoi ongelmasta