Harley Benton SC-400 SGT Classic Series

Bought this for a temp guitar, just to have something to play with during my overseas work assingment of few months. Pricewise it's affordable but you get what you pay for.

At first glance it looks great. No issues with the finish and it was set up OK straight out of the box. It's rather light and comfortable to hold in your lap like any other LP-shaped guitar.

After a few minutes you start to realise where the manufacturer cut cost in order to shave the price. The fret edges are sharp and will hurt your hand if you play extensively. Also the sound is nothing to write home about (especially when plugged into a similar price range amp). Factory strings are not good and you should change those. The tuner knobs felt wonky when restringing.

Having played higher quality guitars before, this was definitely a disappointment in terms of sound and build quality.

However, considering the price and how good it looks, it'll make a great first guitar or for occasions when you just need something quickly and don't mind parting with it later. Next time i'll get something of higher quality (and price)

Contrary to some reviews here from an older date, quality control seems to be on top of all issues mentioned.
First: I also own a real Les Paul standard from the seventies.

I received this guitar in mint condition.
Playability is really, really good.
Hardware is spot on.
These two makes no serious guitar teacher is going to laugh at you: it is MORE than playable, with a light to medium setup out of the box.
There are no dead spots, tuners are really good. Intonation is really good, even compared to my real old Les Paul standard.
I always test my guitars on a Pignose amplifyer, because it reveals the electronics very well, you need to use the tone and volume controls to obtain a good sound.
Well, excellent!
Don't expect real Les Paul tone, though, although the pickups aren't bad and have a sweet sound.
But you can expect better than Gibson playability. Compliments for such improvemt in factory setup.
In my days, when I started playing, I had an Eko and a Hondo (with dimargio desinged pick-ups). These two look like bow and arrows nowadays,
Excellent for beginners. A good back-up for more advanced players.

I play for over 45 years.
Guitar teachers, take note!

HB SC-400 GT

Pros
Cost

Neutral
Finish - Top is not smoothly finished
Pickups - not wax potted
Controls - Pots, Switch and Knobs
Nut - Plastic

Cons
Fret finish
Bad Fretboard due to fret work
(fretwork was the downfall of this guitar)

This is my 3rd Harley Benton, and was purchased with the plan to gut it and use the body / neck as a base to for complete modification. Keep that in mind.

Ordering and shipping from Thomann was flawless. However US customs held the order for a week, then charged a US duty fee. This is stated on the Thomann website, so don't get upset IF it happens to your US order. This is the first time I've been hit with the US customs duty, so I feel fortunate.

The guitar arrived in good shape, no damage and is as described on the Thomann website.
The Gold Top is really more of a Copper color, but does resemble the images on Thomann's website. So, don't expect a "Gold" gold top. The dull / matte finish on the back and neck looks and feels really nice, it does show fingerprints and sweat a great deal. The Copper top color is a rather rough finish to the touch.
In my case the finish of the top doesn't matter as will be sanded and recolored.

The plastic volume and tone knobs do their job, but are really cheap in appearance. This should not be a surprise as this is a very low-cost guitar.
The pots function well, smooth and decent response. They are very small in diameter. They've already been pulled from the guitar, not because they don't work, just because I have better full-size replacements ready to go in.

The pickups have fair sound, and as delivered were NOT wax potted, so you can get microphonic noise quite easily.
Again, not a problem for me, I have different pickups for it anyway.
The 3-way switch is a very low-cost box switch. It does not appear to be the same switch used in my SC-450Plus VB.
This switch works, and that's about it. Not smooth nor quiet. Again, no surprise a very low-cost guitar.

The strings go without saying, but I?ll say it anyway. They have to be replaced as soon as you are done with the initial unboxing excitement.
The action was set very high as received, not a problem, and with the action lowered the guitar played well - with exception.

Here's the problem, even thought the frets we incredibly level, they lacked proper crown and finish.
And if that were the only problem, I'd be set. Unfortunately the fret ends were beveled back too far, and cause fretting issued on the high "e" string. The extreme angle of the fret bevel allowed/caused the "e" string to easily go off the neck when fretted. NOT GOOD.

The nut is a pre-slotted plastic variety, and works well for what it is. It had one little drop of glue holding it in place and came off with a light tap. A new nut will be easy to install.

The fingerboard and inlay finish was actually very good. The fingerboard radius is 12". The inlays are nicely fit and finished.

The vintage style tuners look like the same used on the SC 450Plus, but don't feel as smooth. Not sure if they are a lower quality look-alike version, or just a bad set. They don't all feel the same, some turn easier than others, some bind. I have ordered replacements tuners.

The Bridge and tailpiece appear to be the same as the SC-450. The posts are a bit loose, but don't cause any issues and can be addressed rather easily. I may or may not replace them. Some people really complain about the deep cut bridge saddles, but I'm finding no real reason to discard them for the depth of the string groove. The bigger issue is the slop in the posts as I mentioned before, and that can be fixed.
The tailpiece is grounded to a control pot, that's a good thing.
One issue with the TOM style bridge is the Saddle Retainer Springs don't properly sit in the Bridge Screw groove. This is a design/production issue, common to most/all HB TOM bridges I believe. Can be fixed, or replaced. I'm fixing this one for now, may replace in the future if the need arises.

In hind site, I should have purchased another SC-450 for ± $20 more, overall the 450 is a better guitar, even though they share many of the same components.

For my purposes this guitar will be fine in the end, as I already have all the upgrade components, and have made many modifications to the body, fingerboard, and peg head.

If you are looking for a First guitar, spend a couple more dollars/euros, and get the SC-450Plus. It is worth a little extra, but realize the frets will still need to be cleaned and polished, the fingerboard will need to be cleaned, and you will need new strings.

I have modified nearly every part of this guitar at this point, and that was the reason I had originally purchased this guitar.
As delivered, the guitar was not really playable due to the fret issue, please keep that in mind. If I would have intended to plug-n-play, I would have had to send it back to Thomann.