Fryette Power Station 100

3

Dual-Mode Reactance Amplifier

  • Easy-to-use power attenuator for volume control of high-performance tube amplifiers without the disadvantages of a conventional attenuator
  • Two remote-controlled, foot-switchable controls on the front for volume, presence and depth for maximum flexibility during live performances
  • Powerful mono block with 100 W from 2 KT88 tubes for incomparable response and dynamic range
  • Active safety bypass function deactivates the internal power amplifier and maintains the critical load of the amplifier if the loudspeaker output socket is accidentally unplugged
  • Output power: 100 watts at 2/4, 8 and 16 ohms
  • Tubes: 1 x 12AX7, 2 x KT88
  • Power consumption (max.continuous): 200 W @ 2/4 Ohm, 150 W @ 8 Ohm, 200 W @ 16 Ohm
  • Channel A slider: Volume, Presence & Depth
  • Channel B slider: Volume, Presence & Depth
  • Balanced line output with level control: XLR
  • Unbalanced line output 6.3 mm jack
  • FX Send & Return: 2x 6.3 mm jack
  • Speaker output: 6.3 mm jack
  • Remote foot switch socket: 6.3 mm stereo jack
  • Dimensions (W x H x D): 355 x 91x 228 mm
  • Weight: 7.3 kg

Switches:

  • Channel A / B
  • Hi / Lo input level
  • Treble Response (Flat / Brite / Edge)
  • Low Frequency Response (Presence / Bass)
  • Bypass (standby)
  • Amplifier impedance: 2/4, 8 or 16 ohms
  • FX level Hi / Lo
  • Speaker impedance: 2/4, 8 or 16 ohms
  • Ground lift

Connections:

  • Balanced line output with level control (XLR)
  • Unbalanced line output 6.3 mm jack
  • FX-Send & return (2 x 6.3 mm jack)
  • Speaker output (6.3 mm jack)
  • Remote footswitch (6.3 mm stereo jack)
  • Dimensions (W x H x D): 355 x 91x 228 mm
  • Weight: 7.3 kg
Myynnissä vuodesta Huhtikuu 2020
Tuotenumero 491195
Myyntierä 1 kappaletta
1 199 €
Ilmainen toimitus sis. ALV:n
Saapuu varastoon arviolta viikon kuluessa
Saapuu varastoon arviolta viikon kuluessa

Tuotetta saatavilla pian varastoon ja lähetykseen.

Tietoa lähetyksestä
1

3 Asiakkaiden arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
S
All-in-one solution for non-master volume amps
Stevo1959 07.05.2020
A top-notch quality attenuator, transparent tube power amp and fx-loop in a compact case that fits into 2U height (rackmount kit is sold separately) or on top of a guitar head. Mine comes with matched Sovtek 6550WE power tubes and Ruby 12AX7C5 HG driver & phase inverter tube. According to manual, KT88 tubes can be also fitted without biasing.

I use it with home-built 100W 1959 SuperLead (no built-in fx-loop, no built-in line-out). I needed to solve master volume, post-amp fx-loop, and solo boost. Before I discovered this device, I had to reamp it, which included a load-box for the first speaker out jack (Palmer PDI-06-16), line-out box for the second speaker out jack (served as post-amp fx-loop), and finally solid-state amp to amplify the signal. This was a little bit complicated setup.

I recommend you to set the input and output impedance to match the settings as your amp was connected straight to the speakers, because it is easy to switch the bypass button and you might get into trouble with mismatched impedances between your amp and speakers.

Pros:
+ reactive load. you would hardly hear the tonal difference between bypass and attenuated mode, very transparent
+ adjustable volume from silent recording across bedroom level to full 100W power
+ two channels with individual volume, presence and depth settings, switchable either by front panel button or footswitch (not part of the package). suitable for lead and rythm
+ silent recording option via line-out (balanced or unbalanced), even without powering the device
+ no-load protection (internaly switched speaker jack to a dummy load)
+ separate 2/4, 8, 16 impedance selection for amp in and speaker out
+ bypass the whole thing by a flick of a switch
+ post-amp fx-loop with level settings
+ line-in for connecting any device; e.g., pre-amp, phone, etc.
+ no need to bias
+ ground lift

Cons (very very slight):
- single speaker output. in comparison to PS-2, the second speaker output has been replaced by a footswitch jack for TRS cable to control the FX-loop and channel selection. if you want to connect a full stack (e.g. two 4x12" cabinets), you have to use Y speaker cable or Palmer CAB M Merger
- fx-loop can be switched on/off remotely only; e.g. with a footswitch pedal
- rack mount kit not included

If you have a non-master volume non-fx-loop amp you love to play and you play in a band with other guitarist, this is a must have. You will love it. Period.
Ominaisuudet
Ääni
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate de
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
R&
Sehr guter Attenuator
Rock & Roll 16.01.2021
Ich suche und verwende schon seit Jahren Attenuatoren (Marshall Power Brake, Marshall SE100, THD Hot Plate, TAD Silencer,...) aber bisher konnte nur der OX klanglich überzeugen.
Bei meinem Lieblingsamp, dem Marshall 1974x gehen beim OX allerdings  ab Stufe 2 deutlich Höhen und Dynamik verloren. Und das ist genau der Bereich, den ich zu Hause nutze. Deshalb habe ich mir als Alternative die Power Station 100 zugelegt.

Was mir als erstes aufgefallen ist, ist das die Power Station 100 ganz schön Gewicht hat. Getestet habe ich sie natürlich an meinem 1974x. Und was soll ich sagen? Ich finde die Power Station 100 klingt großartig. 
Schön transparent, die Dynamik bleibt, auch wenn ich die Lautstärke deutlich reduziere. Und durch die kleinen Soundhelfer Presence, Depth, Brite, Warm lassen sich tonale Abweichungen dezent anpassen, ohne den Klangcharakter zu verändern.
Super ist auch, dass das Gerät einen Bypass hat, sodass man den Originalklang immer wieder aufrufen, mit den "reduzierten" Klang abgleichen und mit den Soundhelfern ggf. dann anpassen kann.
Und zu guter Letzt ist die Lautstärke Regelung stufenlos, was ich beim OX sehr vermisse.
Alle anderen Funktionen (Verstärkung, FX Loop,...) habe ich nicht ausprobiert, weil ich diese Funktionen nicht brauche.

Der OX hat ohne Zweifel auch seine Stärken und ich werde ihn auch weiter nutzen aber die Power Station 100 ist mit seinen Features der best klingende Attenuator, den ich ja hatte.
Ominaisuudet
Ääni
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate it
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
Geniale! Per professionisti e non solo.
A.Bono 16.11.2020
Ho acquistato qualche mese fa la Fryette PS-100 qui su Thomann e devo dire che è il migliore acquisto che abbia mai fatto. Praticamente può fare tutto: Attenuatore, power amp, la puoi collegare ad un mixer tramite xlr, puoi mandare il segnale dry ad un processore di effetti. La caratteristica migliore di tutte è che ha il proprio send&return: per gli amanti degli amplificatori vintage come me è utilissimo, in quanto questi ultimi sono sempre sprovvisti del S&R e modificarli ne comprometterebbe il valore. Invece, tu mandi il segnale di un riverbero moderno nella Fryette e pensa a tutto lei! Il fatto di avere due canali poi ti dà molta flessibilità a seconda del suono che vuoi ottenere. In più è valvolare, quindi suono caldo e via dicendo. L'unica pecca è la mancanza di un formato rack. La Fryette mette a disposizione un kit di adattamento sul proprio sito (acquistato subito) ma secondo me Thomann dovrebbe tenerlo a catalogo, in quanto chi utilizza questo tipo di device prima o poi ha necessità di infilarlo in un rack.
Ominaisuudet
Ääni
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

Liittyvät YouTubesta