Doepfer A-111-3

11

Micro Precision VCO / VCLFO

  • Switchable between LFO and VCO modes
  • The range of the Tune control can be changed by jumper - position 1: 16 Hz to 20 kHz, position 2: 16 Hz to 70 Hz, without jumper: 16 Hz to 22 Hz
  • Width: 4 HP
  • Depth: 65 mm
  • Power requirements: +40 mA (+12 V) / -40 mA (-12 V)
Myynnissä vuodesta Syyskuu 2016
Tuotenumero 399219
Myyntierä 1 kappaletta
Analog Yes
Digital No
Width 4 TE / HP
variants Doepfer
159 €
Ilmainen toimitus sis. ALV:n
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu lähetyspäivä Keskiviikko, 24.04. mennessä
1

11 Asiakkaiden arviot

4.6 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Käyttö

Ominaisuudet

Työnjälki

9 Arvostelut

m
A lot of punch in small hp
mkok 31.07.2018
Accurate VCO and LCO in one compact package. Quite deep module, so wont fit well into TipTop audio mantis case (fits only top row left-/rightmost corner)
Käyttö
Ominaisuudet
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
N
Nightjar 21.05.2019
A great starting vca, and a great tool to more extensive rack due to the LFO as it can crossmod and make a fair few shapes. However it is on the small side so it can get crowded, but that's part of the charm
Käyttö
Ominaisuudet
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
JM
One of the best start VCOs
Jon Mayo 04.03.2024
This tiny little CEM3340 based oscillator is my #1 recommendation for someone looking into getting to Eurorack modular. It has all the key functionality and takes up little HP. And it can be useful to supplement a larger multi-voice patch.

The quality of Doepfer's knobs is perhaps the best in the industry. Their modules, including this one, are deep and won't fit some shallow skiffs. So check the depth!

Features I think are important for a good starter VCO that this VCO has. 1V/Oct tracking over a wide number of octaves (15 octaves according to Doepfer!). Exponential FM input, for 2OP-like FM sounds with another oscillator. Linear frequency modulation for vibrato effects. Soft and hard sync (I use hard sync mostly, so I have the jumper set there).

Or buy 2, and a noise generator (Doepfer A-118-2) and start making your own drum sounds.
Käyttö
Ominaisuudet
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
r
It's fine
raindeer 04.08.2020
No nonsense product. I'm using other oscillators so this one is really good for modulating them at all kinds of rates. I can't quite figure out how to get the LFO down to the 0.001Hz (more like 0.05) but it may be possible using an external source.
Käyttö
Ominaisuudet
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta