Doepfer A-110-2

29

Basic VCO for the A-100 modular system

  • Voltage controlled oscillator
  • 3-Position toggle switch
  • Linear FM input and soft-sync input
  • Tune control range can be set between approx. 1/2 octave and 4 octaves via a jumper
  • Width: 8 HP / 40.3 mm
  • Depth: 50 mm (measured from the rear of the front panel)
  • Power requirements: + 12V: 150 mA (warm up period about 30 seconds), 60 mA (continuous operation) -12V: 30mA
Myynnissä vuodesta Joulukuu 2014
Tuotenumero 354853
Myyntierä 1 kappaletta
Analog Yes
Digital No
Width 8 TE / HP
variants Doepfer
125 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu lähetyspäivä Perjantai, 19.04. mennessä
1

29 Asiakkaiden arviot

4.6 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Käyttö

Ominaisuudet

Työnjälki

15 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
High quality, and surprising differences from A-110-1
Tuntematon 18.12.2015
The A-110-2 Basic Oscillator is a great-sounding oscillator, with interesting additions to the A-110-1 Standard Oscillator. While the -1 has a 5-position switch for octave, the -2 has only 3 positions. The -2 also sacrifices the sine output from the -1.

While the -1 has linear FM (i.e. a second 1V/Oct CV input with an attenuator), the -2 also has exponential FM. And while the -1 has a sync input, the -2 has both hard and soft sync inputs. The -2 has only one input for pulse width - but that seems like a reasonable sacrifice for the other features.

I find that the A-110-2 doesn't track as well as the A-110-1 in high ranges, and the sound is a bit "grittier" than the A-110-1. I actually like the square wave output of the -2 better than that of the -1, and since I have two of each, I tend to use them together to add texture to patches.

All in all, for the small price savings and the 2HP difference in width, I would tend to buy the -1 first - but I would buy a -2 to go with it, too.
4
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
KZ
Excellent !!
Kamil Z. 16.05.2016
Really great VCO it complements the Standard more expensive VCO very well. the soft sync is a must and differs a lot from hard sync, be careful though this unit is rather higly tuned and 0 pos does not correspond to 0 on the standard VCO, you can tune it down 2 octaves so no issues but will remain 1 octave above the lowest setting of the standard 110.

Higly recommended.
2
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
Good compact VCO
Tuntematon 15.03.2016
Affordable and compact which is good if rack space is a concern. I use it as an addition to my Arturia Microbrute but it sounds great even on its own with a few effects.
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
O
..is doepfer
Oskars 30.12.2016
Great features. Solid sound. Not a very shallow module.
0
0
Raportoi ongelmasta

Raportoi ongelmasta