Radial Engineering SB-6

Vis oversættelse

Stereo Isolator

Eliminates hum caused by ground loops
For balanced and unbalanced signals
Linear frequency response from 20 - 20,000 Hz
2x 6.3 mm Jack inputs
2x 6.3 mm Jack outputs
Switchable ground lift for both channels
Switchable pad
Switchable phase for the left channel
Robust metal housing

30 30 dages-Money Back garanti

3 3 års Thomann garanti

Fås siden December 2014

Artikelnummer 351955

salgsenhed 1 stk

Multi-Channel Unit Yes

Channels 2

Active / Passive Passive

19" No

Pad switchable Yes

Gnd/Lift switchable Yes

Speaker Simulation No

1.269 kr

Alle priser inkl. moms

Gratis levering. Forventet mellem onsdag, 24.04. og torsdag, 25.04.

Salgsrang

i DI/ linedrivers

Kunder som så på dette produkt købte dette

Radial Engineering Pro D2

1.648 kr

købt

Radial Engineering SB-1

711 kr

købt

Radial Engineering SB-2

34 Kundebedømmelser

5 27 Kunder 4 3 Kunder 3 2 Kunder 2 2 Kunder 1 0 Kunder

4.6 / 5

features

lyd

forarbejdning

Retningslinjer for anmeldelser

24 Anmeldelser

Great with my stereo rig

JThorn 24.03.2021

I use this for a stereo setup. I run my guitar signal through my pedalboard, and then split the signal out to two amps from an end-of-chain stereo reverb pedal (Neunaber Expanse). Now I run the stereo signal from the reverb into this, and then out to the two amps. Both amps have a ground connection. Not only does the SB-6 lifting ground to one of the amps eliminate a lot of hum, but the phase reversal button also turned out to be handy, cause it turned out that my two amps had been out of phase up untill now, and I just didn't know what I was missing. This increased clarity a lot. Mind you, this will only take care of ground-loop noise and out-of-phase problems, you still need a good-quality powersupply with isolated outputs going to each pedal to take care of the rest of the noise! But these things combined sure made a big improvement to noise-levels in my rig. Also, build quality seems solid and top-notch. It has soft padding on its underside, so if you plan to mount it on top of your pedalboard, you'll have to remove that and replace with velcro. I keep it underneath my Pedaltrain Novo 24SC board, where it just about fits, and I'm planning to secure it to the underside of the board with velcro if possible.

Anmeld bedømmelse

Synes du at denne vurdering er forkert eller af en anden grund ikke læselig? Vær venlig at skrive i det følgende kommentarfelt hvorfor og hvis muligt din email-adresse, så vi kan give dig en tilbage melding til din kommentar.

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

Great problem-solving box

FastEddy 10.11.2015

Sometimes you just need isolation without level attenuation - just easy interfacing between equipment that is suffering from ground loop issues due to being on separate ring mains. I've solved issues with humming monitors, FOH speakers and guitar amps with this. It now lives on my pedalboard, to help run balanced lines from a guitar rig to a rack processor and back, TS->TRS->TS, which reduces unbalanced line interference considerably. I also use it at numerous venues, where lighting desks, dimmer controls and even dishwashers are all spewing noise onto the mains. Some of this is cleared up by RF filters, but used in tandem with the Stagebug, you can eliminate just about anything (excl. single coil noise - nothing can save you from this, except humbuckers!). Another use was to put this between an active acoustic preamp and an A&H desk's Inst input, as I had run out of DI channels but still wanted isolation from the desk. Useful PAD and polarity etc. should you need it. Managed to fit this beneath my pedaltrain so it is out of the way. Very solid and well made, and well worth the money, even if you just keep it in your toolkit until it's needed.

Anmeld bedømmelse

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

Ogunya 02.01.2020

It is my second unit and works as expected.

Anmeld bedømmelse

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

Incredibly useful

PapaJoe 19.04.2021

Use it for running wet/dry, as a split or just for isolation when using a switcher. Great sound, phase switch, ground lifts... what more do you need? Another SB-6, for any other problem you might have :)

Anmeld bedømmelse

Læs alle anmeldelser

Radial Engineering SB-6

Stereo Isolator

Kunder som så på dette produkt købte dette

34 Kundebedømmelser

Du skal være logget på, for at kunne vurdere et produkt.

24 Anmeldelser

Smart Navigator

Artikel historik

Handl og betal sikkert

Dine fordele

Service

Serveret med kærlighed!

Radial Engineering SB-6

Stereo Isolator

Kunder som så på dette produkt købte dette

Tilbehør og matchende produkter

34 Kundebedømmelser

Du skal være logget på, for at kunne vurdere et produkt.

24 Anmeldelser

Sammenlign valgmuligheder

Smart Navigator