• Huskeliste
  • Vælg butik Select Store
    Alle Lande All Countries
  • 0

Den store Thomann online-rådgiver: PA Speakers

4. Making Connections

There are three ways to connect loudspeakers: in parallel, that is each speaker receiving a direct signal from the amp; in series, or one after the other in a single (electrical) line from the amp; and in combinations of series and parallel connection. In some instances, speakers are connected via a crossover which distributes frequencies between the speakers, in which case the characteristics of the crossover will apply.

In guitar speaker cabinets or combo units, the speakers will be wired to match the specification of the amplifier, whether it is built-in or external.

The key consideration is the impedance, or resistance. It’s like the narrowing of a stream of water - the narrower the gap, the more force is required to get the water through. In this instance, the higher the impedance, the more power you need to drive the speaker.

If the impedance of the speakers is higher than that of the amp, then you will get less than optimum performance from the speakers. If it’s less, then you risk damaging the speakers.

Parallel connection
Series connection

Combined series and parallel

The following table shows impedance values for various combinations of speaker connections:

Speaker
Combination
Individual
Impedance
Circuit Total Impedance
4x 12" 4 Ohms 2 x 2 LS in series,
2 Pairs parallel
4 Ohms
4x 12" 4 Ohms 2 x 2 LS in series,
2 Pairs series
16 Ohms
4x 12" 8 Ohms 2 x 2 LS in series,
2 Pairs parallel
8 Ohms
4x 12" 8 Ohms 2 x 2 LS in series,
2 Pairs series
32 Ohms
4x 12" 16 Ohms 2 x 2 LS in series,
2 Pairs parallel
16 Ohms
4x 12" 16 Ohms 2 x 2 LS parallel,
2 Pairs parallel
4 Ohms
2x 12" 4 Ohms Series 8 Ohms
2x 12" 4 Ohms parallel 2 Ohms
2x 12" 8 Ohms Series 16 Ohms
2x 12" 8 Ohms parallel 4 Ohms
2x 12" 16 Ohms Series 32 Ohms
2x 12" 16 Ohms parallel 8 Ohms

In this instance, the speaker size is given for reference only - it’s the impedances that count. Electrical impedance is independent of speaker size.

The most common individual speaker impedance is 8 Ohms, and where speakers are combined in cabinets, they are often wired to produce a total impedance of 8 Ohms. There is usually a plate on the cabinet stating the technical specification.

Cabinets will also often have a socket for the connection of another set of speakers, which is generally wired in parallel. If you add another 8 Ohm cabinet, the total impedance drops to 4 Ohms.

Kontaktperson
Tlf: +49-9546-9223-35
Fax: +49-9546-9223-24
Få fat i disse gratis Hot Deals!

Mere end 7.900.000 musikere læser dem allerede: Thomann Hot Deals. Hent nu dit gratis eksemplar med mere end 500 aktuelle tilbud!

Hot Deals
En Thomann-fan
Super fed forretning, I har kørende - den er bare klasse.
Mikkel, 16.05.2015

PA Speakers Et overblik over

(14)
(1)
(2)
Feedback

Har du fundet en fejl eller har du kommentarer til denne side?

Tak for din feedback! Vi løser problemet snarest muligt.

Afbryd