• Huskeliste
  • Vælg butik Select Store
    Alle Lande All Countries
  • 0

Den store Thomann online-rådgiver: Guitar Wireless Systems

2. Transmission / Reception

Instead of the usual instrument cable, wireless systems use radio waves for transmission of the audio signal. The transmitter, which is connected to the guitar, converts the guitar output into an FM (Frequency Modulation) radio signal and broadcasts this using an integral antenna. In some rare cases, other modulation schemes are employed – AM (Amplitude Modulation) for example. Digital transmission of wireless audio, as used in Bluetooth headphones is also available, but this technology is more expensive, and only recently considered mature enough to offer the guitarist a reliable hook-up. But more on digital later - at the time of writing, FM is by far the most common method in use.

A guitar-strap attached transmitter from AKG

The receiver, which is directly connected to the amplification system (maybe through your pedals first), picks up the signal via its own antenna and subsequently converts the radio waves back into the original guitar signal, with as little distortion or degradation as possible. In principle, for each transmitter there should be a single unique receiver. Different transmitters used simultaneously in the same local area must operate on different ‘channels’, so as not to interfere with one another, and just like a standard analogue radio set, a receiver can only tune in to one channel at a time, so multiple receivers must be used and each set to the channel of its corresponding transmitter. Some receivers are modular and appear to receive several channels at once, but in reality, these simply use several receivers in a single housing and offer no technical advantage over a group of discrete receivers - there may well be cost and space savings though.

Wireless systems are usually supplied as a complete set so that transmitters and receivers are well matched. It is possible to mix-and-match devices from different manufacturers, but some skill is needed to optimise performance, and in some cases, proprietary hand-shaking communication between transmitter and receiver will be lost. The transmitter unit will either be designed to attach to your guitar strap, in which case a short jack lead is needed to connect the guitar output to the transmitter input, or the transmitter will be a single unit with an integrated jack plug to insert directly into your guitar. These fully integrated types usually come in two flavours in order to accommodate the different angles of the Fender Stratocaster style output (diagonally set), and the Gibson Les Paul (right angled) configuration.

Samson Airline Guitar wireless system. Note how the receiver is designed like a stomp box - very convenient as it can be installed on your pedal board.
Kontaktperson
Tlf: +49-9546-9223-35
Fax: +49-9546-9223-24
Tlf: +49-9546-9223-20
Fax: +49-9546-9223-24
Få fat i disse gratis Hot Deals!

Mere end 7.850.000 musikere læser dem allerede: Thomann Hot Deals. Hent nu dit gratis eksemplar med mere end 500 aktuelle tilbud!

Hot Deals
En Thomann-fan
Thomann, you never stop amazing me! Thank u very much, u guys are great! :-)
Rich, 16.05.2015
(14)
(1)
(3)
(1)
(2)
Feedback

Har du fundet en fejl eller har du kommentarer til denne side?

Tak for din feedback! Vi løser problemet snarest muligt.

Afbryd