Til sidens indhold
seventy years logo
Thomann fejrer jubilæum! Tak for din loyalitet! Udforsk vores jubilæumstilbud allerede nu Til tilbudene

Millenium DS200 Black

153

Table Microphone Boom Arm

  • Aluminium construction
  • Locking centre joint
  • 5/8" threaded connector
  • Table clamp for up to max. 56 mm table thickness
  • Pre-wired with XLR cable
  • Length of upper arm: 43 cm
  • Length of lower arm: 40 cm
  • Maximum load capacity: 1.5 kg
  • Colour: Black
Fås siden September 2018
Artikelnummer 437359
salgsenhed 1 stk
Type Microphone Boom
Colour Black
Weight 1,8 kg
Vis mere
B-Stock from 491 kr tilgængelig
529 kr
Inkl. moms. Obs! Yderligere fragtomkostninger 45 kr
på lager
på lager

Produktet er på lager og klar til afsendelse.

Information om forsendelse
Forventet levering mellem torsdag, 10.10. og fredag, 11.10.
1

153 Kundebedømmelser

4.2 / 5

Du skal være logget på, for at kunne vurdere et produkt.

BemærkVi tillader kun vores kunder, at afgive en vurdering af det udstyr de har købt hos os. Vi modtager ikke anmeldelser eller vurderinger af produkter fra tredje kilde.

Efter login finder du også i kundencenter under "vurderinger af produkt" alle artikler, som du kan afgive en vurdering af.

stabilitet

forarbejdning

99 Anmeldelser

A
Terrible build quality
Anonym 03.08.2022
Initially looks good and had a good suspension system. That was until it broke after 10 minutes of usage by simply adjusting the levers. Now I have to tighten every anchor point super tight and it is very very unstable. Would strongly suggest considering another microphone arm if you are looking to buy one.
forarbejdning
stabilitet
0
0
Anmeld bedømmelse

Anmeld bedømmelse

Ff
Ikke i top
Finn fra Radio ALR Denmark 23.10.2023
Denne mellemrum DS200 er ikke så god som en røde eller Elgato low boomarm. Kvaliteten ved Mellium skal gøre en del bedre, og den skal kunne løfte de tunge mikrofoner langt bedre end den gør lige pt.
forarbejdning
stabilitet
0
0
Anmeld bedømmelse

Anmeld bedømmelse

google translate gb
Der opstod en fejl. Prøv igen senere.
P
not bad but room for improvement
PKristoffersson 13.02.2020
I bought this table microphone stand so I could do work either sitting or standing by my desk, depending on whether I would be singing or speaking.

This stand supports my microphone (a t-bone 400) with no issue and the reach is long. However, adjusting it is a bit of a pain. There are three separate joints that need to be tightened. The joint closest to the microphone is rather limited in its range of motion. Also, since all joints are hinge type joints it's not easy adjusting to get the microphone exactly where you want it. Overall it's something one can work around, it just takes time.
2
1
Anmeld bedømmelse

Anmeld bedømmelse

google translate gb
Der opstod en fejl. Prøv igen senere.
S
had this for about 1 year
SixStackJack 06.01.2022
bought this one coas i needed a somewhat cheap boom arm for my AT2020 mic, and it works great, the arm keeps still and its somewhat easy to adjust it to your needs,
i had some problems getting the part where you fasten it to the table to stay in place, so i ended up drilling two holes from the top of the "plate" into the table, and then screw it in :D. now it wont move eaven if there was an earthquake :;D
forarbejdning
stabilitet
0
0
Anmeld bedømmelse

Anmeld bedømmelse