Jaspers 4D-145B

Start 360°

Vis oversættelse

Keyboard Stand

For 4 keyboards
Made of black powder-coated aluminium
Height: 140 cm
Width: 155 cm
Inner width: 145 cm
Maximum adjustable depth: 70 cm
With hand wheels
The lower section, reinforced by a second tube, has a pair of 60 cm long supports and is also suitable for particularly heavy keyboards
The other supports are 40 cm long
Load capacity: Lower shelf up to 40 kg / upper shelves up to 15 kg (or more, with shelf reinforcement as below)
All shelves are height-adjustable and tiltable
Can also be folded for transport
Made in Germany
Suitable accessories: Additional pairs of shelves, monitor support, micro swivel arm, music stand, laptop shelf (not included)

30 30 dages-Money Back garanti

3 3 års Thomann garanti

Fås siden Marts 2005

Artikelnummer 176571

salgsenhed 1 stk

Keyboard Supports 4

2.190 kr

portofrit og inkl. moms

Afsendelse forventet onsdag, 17.04.

Salgsrang

i Keyboardstativer

Kunder som så på dette produkt købte dette

81 Kundebedømmelser

5 66 Kunder 4 11 Kunder 3 1 Kunde 2 1 Kunde 1 2 Kunder

4.7 / 5

stabilitet

håndtering

forarbejdning

Retningslinjer for anmeldelser

57 Anmeldelser

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

Works!

M Gho 30.11.2020

Works Perfectly

Only "issue" is that it takes a while to setup

I suggest you prepare the following
1) Cordless Drill with the correct HEX BIT (you will adjusting the fittings a lot)
2) Measuring Tape. This is the only way to get things aligned properly. Make sure each T-fitting is the same distance from the floor (for the left and right A stand) so you end up with a perfect stand
3) Bubble Level. Make sure all your horizontal tubes are level. Also when you are adjusting the holders, You can use the level to make sure the 2 holder arms are parallel. I used an iPhone App, but a bigger physical bubble level will be more useful
4) make sure you jam the fitting into the horizontal bar then u use the locking clamp to make sure it does not twist. Once you do one side, repeat on the other side. Make sure while u are jamming the opposite side, the original side does not pop up. I was lucky my 88 key piano did not drop down the next day. Again double check

Anmeld bedømmelse

Synes du at denne vurdering er forkert eller af en anden grund ikke læselig? Vær venlig at skrive i det følgende kommentarfelt hvorfor og hvis muligt din email-adresse, så vi kan give dig en tilbage melding til din kommentar.

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

Nothing like Jaspers

Endre Ottem 27.08.2017

I've had this stand for a couple of years now, and I'm absolutely thrilled about it. I have used almost everything there is as far as keyboard stands go, but there's just nothing like Jaspers. The stand is extremely sturdy and the option to add holders makes it very configurable. I currently use it to hold a Motif XS-7 and a Kronos 73 (both very heavy synths) in addition to a lot of smaller synths and controllers. I've added the strengthening set though. I haven't seen any other stands that offer the same flexibility and stability as the Jaspers stands.

Anmeld bedømmelse

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

Briliant stand when used with care

GilBa 23.09.2023

I ordered this stand and immediately proceeded to put it together without consulting the manual or youtube. What could be hard about setting up a stand right? Wrong move.

I didn't lock the fasting rings, causing my Moog and Minilogue s on the uppermost tier to turn upside down and come sliding down. Just as this was happening, I was holding my Korg M1 that I was trying to insert on a middle tier, creating the crazy situation of me holding 3 synths with nowhere to go. To top it off, my Kronos on the lowest tier came crashing down on the floor because I didn't properly lean the two support beams on the extra lateral beam and didn't set the diagonal sides in the right angle.
I'm telling you this so you may avoid this.

Putting this stand together requires:
- Planning - where do you want to put what piece of gear and at what angle?
- Read the manual or watch youtube howto's first
- Use a spirit level to make sure everything is straight
- Use a centimeter to make sure all the angles are correct and are consistent L/R
- Fasten everything properly using the included hex tool (Be prepared to do a lot screwing as you adjust/perfect your setup)

Once set up, it's a brilliant stand. I love the amount of space at the bottom, I now have a small rack of 19" inch gear there and there's still plenty of room for sustain pedals and so on. The stand is light weight and can be expanded with all kinds of extensions. The lateral beams can be used to esthetically guide cables using cable ties which looks very good (I use Thomann V2030's).

Anmeld bedømmelse

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

Good 4 keyboard stand

Gibmini 26.11.2019

Pretty stable, even with heavy keyboards like a Kronos. However, there is limited space between the keyboards so it can be hard to see buttons/screens.

Anmeld bedømmelse

Læs alle anmeldelser

Jaspers 4D-145B

Keyboard Stand

Kunder som så på dette produkt købte dette

81 Kundebedømmelser

Du skal være logget på, for at kunne vurdere et produkt.

57 Anmeldelser

YouTube på dette emne

Smart Navigator

Artikel historik

Handl og betal sikkert

Dine fordele

Service

Serveret med kærlighed!

Jaspers 4D-145B

Keyboard Stand

Kunder som så på dette produkt købte dette

Tilbehør og matchende produkter

81 Kundebedømmelser

Du skal være logget på, for at kunne vurdere et produkt.

57 Anmeldelser

YouTube på dette emne

Sammenlign valgmuligheder

Smart Navigator