K&M 11510 Sheet Music Holder

71

Sheet Music and Document Holder

  • For horizontal and vertical mounting, for example on table edges or stand tubes
  • Adjustable inclination and spacing
  • Material: Steel
  • Supporting surface 300 x 200 x 30 mm
  • Clamping range: up to 53 mm
  • Arm length: approx. 180 mm
  • Weight: 1 kg
  • Colour: Black
Tillgänglig sedan Maj 2015
Artikelnummer 362940
försäljningsenhet 1 Styck
Shelf No
Drink Holder No
Carrying Bag No
Music Sheet Holder Yes
Magnets No
Single Console Panel No
Single Stand No
Carrying Trolley / Case No
Parquet Saver No
Desk Extension No
Sheet Music Clip No
B-Stock från 381 kr tillgänglig
444 kr
inklusive moms, 99 kr frakt tillkommer
i lager
i lager

Produkten finns i lager och kan levereras omgående.

Information om leveransen
Leverans beräknas mellan Torsdag, 4.04. och Fredag, 5.04.
1

71 Kundbetyg

4.4 / 5

Du måste vara inloggad för att kunna betygsätta en produkt.

Obs! För att undvika att betygsättningen är byggt på rykten eller smygreklam kan bara kunder som har köpt produkten från oss sätta sitt betyg.

Efter inloggningen i kundcentret kan du se vilka produkter som kan betygsättas.

hantverkskvalitet

42 Recensioner

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
D
Really practical holder
DimitCh 02.04.2021
I bought this music sheet holder for my small room where there is no room for things on the floor. It is attached to my office table and it holds really well. I can now study music without having everything running on my floor, making it impossible to walk around.
I also really like the fact that it is stable and stays in plays without relaxing its grip. The only thing that is a bit unstable (though not a problem for me at least) is the holder itself, which, if turned slightly, will make the screw go loose. After that you have to tighten it a bit to make it stand its position again. But if not moved, it just stays perfectly in place.
funktion
stabilitet
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
JD
Artistic license Added
Jyde D. 11.03.2018
The fact that this holder is tiny, almost an A4 sheet turned sideways makes it very discreet and a lot less bogus than my old music stand, A down side is that I don?t really see it handling lots of books all together. I sometimes stack six or seven text books on top of each other especially when studying.
I used a bit of artistic license and drilled a 5mm by 1.5mm diagonal notch on each of the corner ends of the lip on the tray. This works well with the K&M 11590 : Konig and Meyer Sheet Music Holder. Place the magnet at the back of the tray , centre top and pass the transparent nylon strings over the top of the book to each of the bottom corners of the tray and slot into the notches using the plastic end caps as locking restraints. This inverts the intended use of the K&M 11590 device. K&M take note:-It would be useful to pre-notch the music stand, after all they are both your products.
funktion
stabilitet
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
P
Tablet Holder
Paul7310 15.09.2015
Up to the usual high quality that I expect from Thomann.
funktion
stabilitet
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
J3
Good quality
Justin 3 12.10.2022
Good quality. It holds my beringer mixer, so it really does the job.
0
0
Anmäl recension

Anmäl recension