K&M 23325 Table Microphone Stand

328

Microphone Stand

  • Black
  • Cast-iron base with special rubber insert for silencing
  • Screwed, adjustable tube combination
  • Weight: 2.5kg
  • H: 217-347 mm
  • Base-Ø 180 mm
disponibil din Iunie 2013
numărul articolului 316056
unitate de vânzare 1 bucată(ăţi)
Type Desk stand
Colour Black
159 lei
Include TVA la care se adaugă 89 lei costul de transport
în stoc
în stoc

Acest produs e disponibil în stoc și poate fi expediat imediat.

Informații despre livrare
Expediere preconizată până Vineri, 26.04.
1

328 Evaluările clienților

4.8 / 5

Pentru a evalua produse trebuie să fiţi logat.

Reţineţi: Pentru a preveni evaluările bazate pe zvonuri sau reclame ascunse permitem doar evaluări de lşa clienţii noştri reali, şi care au cumpărat echipamente de la noi.

După logare veţi găsi de asemenea toate articolele care pot fi evaluate Centrul Logare Clienţi.

Manipulare

Stabilitate

Măiestrie

188 Recenzii

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
DD
Feels heavier & sturdier than the photo!
Dr D 01.11.2019
I have a heavy RODE Procaster with shockmount plus TritonAudio Fethead and windshield attached, so I was concerned that a relatively short desktop stand with a not so big base circumference (180 cm or 6-inches) would suffice. Thankfully, I can report that this K&M mic stand is absolutely perfect. It is really quite heavy @ 2.5 Kg ( > 5 lbs) weight, thus can easily cope with more than a kilo of weight up top. In fact, when I grab the head of the mic whilst attached to this stand and try and pull it or tip it over, it just will not.
The other cool aspect of this particular mic stand, is the easily adjustable telescopic pole to adjust the height of the mic. Although it does not increase the overall height by that much, it is sufficient to get the mic up to head head whilst seated at a desk with this stand in front of you. It also secures very well and does not slip or move at all.
Finally, the circular rubber inlay on the rear side of the base, just feels quality - soft but does not allow the stand to slide at all. Even hitting the side of the base with my clenched fist does not move it.
I would highly recommend these K&M mic stands and the next time I shall be in the market for another one, I will look for this brand again.
Manipulare
Stabilitate
Măiestrie
3
1
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
N
Doubles as a battel hammer
Nänad 04.01.2021
Seriously, this thing is so sturdy, you can kill a guy with it. Has a rubber layer on the bottom which prevents it from sliding on top of a desk. RODE NT 1 fits perfectly on top of it. Can be used for recording instruments, but for recording conversations as well...and killing people (in which case RODE NT1 should be replace with Shure SM58, due to it's enhanced rigidness)
Manipulare
Stabilitate
Măiestrie
8
1
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
r
Its decent
rayzer... 03.04.2022
It has a really heavy base so you wont be knocking it over accidentally but i found it sounded a bit hollow when i first used it by my computer.
After sticking some carpet and rubber squares under it that became a non issue.
Other than that its sturdy and does its job.
Manipulare
Stabilitate
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
AD
Nothing not to like.
A Dutch Person 11.01.2021
Reassuringly heavy, thank god. You can extend it 15 cm (unlike the K&M 232BK) which is great. It has a sturdy rubber ring at the bottom to dampen vibrations. It feels rock solid and I will probably also use it for live music (with omni and cardiods) in small interior locations (on table, shelf or chair) when there is no room for mike stands. They won't fall over.
Manipulare
Stabilitate
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz