Adam Hall 5635 Humfrees M6

309

Start 360°

Vis oversættelse

Rack Insulation Against Ground Loops

When rack mounting, additional conducting ground connections are created between 19" devices via the metal rails - the most frequent cause of hum noise.

Humfrees interrupts these ground loops. Devices are attached to the rack rails while electrically separated from each other. Additional plus: The front panels of the devices are protected against assembly damage.

4 M6 screws
4 Insulators
4 Spacers

30 30 dages-Money Back garanti

3 3 års Thomann garanti

Fås siden November 1999

Artikelnummer 128225

salgsenhed 1 stk

Type Set

Thread Size M6

Length 16

Amount 4

Note Rack Isolation

Vis mere

26 kr

Inkl. moms. Obs! Yderligere fragtomkostninger 60 kr

Mængderabat

Stykpris	Du sparer	Mængde
26,00 kr		1
24,49 kr	5,8%	4

Forventet levering mellem fredag, 26.04. og mandag, 29.04.

Salgsrang

i Skruer og nitter

Kunder som så på dette produkt købte dette

Adam Hall 5410BLK Rack Screw Pack

26 kr

14%

købt

Adam Hall 5621 Plain Nylon

14,30 kr

købt

Adam Hall 5651 Rack Nut Pack

49 kr

købt

Adam Hall 5620 Plastic Washer Pack

20,30 kr

309 Kundebedømmelser

5 147 Kunder 4 91 Kunder 3 39 Kunder 2 15 Kunder 1 17 Kunder

4.1 / 5

forarbejdning

Retningslinjer for anmeldelser

137 Anmeldelser

Adam Hall 5635 Humfrees M6

Frank177 24.02.2017

Jeg synes Ikke de leverer hvad de lover
har brugt dem i forskellige racks til både Mixer
og Effektenheder samt Pa forstærkere
der er store problemer med montagen, det er svært at få dem til at sidde korrekt og jeg synes ikke de har nogen hjælpende effekt

Anmeld bedømmelse

Synes du at denne vurdering er forkert eller af en anden grund ikke læselig? Vær venlig at skrive i det følgende kommentarfelt hvorfor og hvis muligt din email-adresse, så vi kan give dig en tilbage melding til din kommentar.

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

bad product

ColmO 18.03.2014

its only true purpose is to prevent against rack rash, it does not isolate equipment from each other, rather it isolates the rack equipment from the rack rails, so if 1 unit is causing hum this will transfer along each unit as their faceplates arent isolated

the screws dont fit my adam hall rack or gator case, it comes with a soft adapter for smaller screws

you have to cut the pieces out of their molds which isnt too difficult, but takes some accuracy to get them looking smooth with no bits sticking out.

the rubber/plastic warps/goes out of shape and shift position before you have the screws tightened, its difficult to gauge when its tight enough, when it feels tight your left with a misshapen piece

I dont normally right reviews straight after using a product but was so let down by these that I felt the need to write a review. some old bicycle inner tube would work better, or 2 plastic washers per screw would achieve the same

Anmeld bedømmelse

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

Your rack deserves the best!

SpyX 14.06.2018

Your rack deserves the best.
If you are a pro you don't need my advice, you know what you'll do. But for the rest of us who build a rack I'll tell you that, this set is a must for your rack.
You have spend a lot of money to buy audio hardware devices, you want the best for your sound so the last thing you want is hum from ground loops created between 19" devices via the metal rails.
Here comes the "Adam Hall 5635 Humfrees M6".
Consists of (4) M6 screws, (4) Insulators and (4) Spacers this is a set for one device. In a very good quality it'll give insulation to your rack against ground loops and protection to the front panels of your devices against assembly damage. Also looks nice aesthetically.
Coming in a good price, don't even thinking to don't make this buying.

Anmeld bedømmelse

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

Quite good

svenoxtoby 11.05.2017

I have used these in many racks with both M5 and M6 screws. These ARE compatible with both M5 and M6 screws because adaptors are provided for M5 screws.

As noted by another reviewer the can get mis-shapen if you are not careful, but this has only been a cosmetic problem for me.

As for isolation, they have worked every time for me (tested). I have not had trouble keeping the faceplates isolated. Important: when testing for isolation/continuity, remember to unplug all of the power cables from power distribution unit to rack devices. Otherwise the meter will indicate continuity, since the devices are joined through the PE/ECC conductor of each piece of gear (and this is how it must be for safety - NEVER cut a ground/PE/ECC conductor.

Anmeld bedømmelse

Læs alle anmeldelser

Adam Hall 5635 Humfrees M6

Rack Insulation Against Ground Loops

Kunder som så på dette produkt købte dette

309 Kundebedømmelser

Du skal være logget på, for at kunne vurdere et produkt.

137 Anmeldelser

Smart Navigator

Artikel historik

Handl og betal sikkert

Dine fordele

Service

Serveret med kærlighed!

Adam Hall 5635 Humfrees M6

Rack Insulation Against Ground Loops

Kunder som så på dette produkt købte dette

Tilbehør og matchende produkter

309 Kundebedømmelser

Du skal være logget på, for at kunne vurdere et produkt.

137 Anmeldelser

Sammenlign valgmuligheder

Smart Navigator