the t.bone Ovid System Flute Clip

238

Modular Flute Microphone Clip

  • For Ovid systems
  • Easy to install without tools
  • Also suitable for transverse flute, clarinet etc.
K dostání od Duben 2012
Číslo produktu 270438
Prodejní jednotka 1 ks
Component type Special Mount
499 Kč
Cena vč. DPH nezahrnuje poštovné 295 Kč
Na skladě
Na skladě

Tento produkt je na skladě a může být obratem odeslán.

Informace o expedici
Odešleme pravděpodobně do Čtvrtek, 18.04.
1

238 Hodnocení zákazníků

3.8 / 5

Musíte být přihlášeni, pokud chcete hodnotit produkty.

Upozornění: Abychom zabránili tomu, že se budou hodnocení zakládat informacích z doslechu, polovičních pravdách nebo skryté reklamě, dovolujeme na našich stránkách hodnotit pouze skutečným uživatelům, kteří u nás vybavení také koupili.

Po přihlášení najdete také v zákaznickém centru v sekci "Hodnotit produkty" všechny produkty, které můžete hodnotit.

Zpracování

93 Recenze

k
kmotr 14.01.2019
Musí být ?lov?k trochu trp?livý p?i nasazování na nástroj (flétna), ale jinak skv?lý pomocník
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
I
Not for flute
IsItMe? 16.05.2020
With good intentions, but not fit for purpose.

Pros:
None

Cons:
Handling noise
Expensive
Velcro supplied better replaced with a velcro cable-tie
Doesn't fit flute well

Velcro is far too long for flute and not "sticky" the whole length - so requires fitting skewed with a tail sticking out to ensure the rubber bit of the mount sits against the body of the flute (or else the whole mount just slides round).

I tried with a velcro cable-tie and this worked better (velcro both sides the whole length)

The show stopper however is the amount of handling and key noise when you're actually trying to use it.

Also....nearly £17 for a small rubber mount and a bit of velcro is really poor value.
Zpracování
2
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
C
Half the price of the DPA clip....unfortuately half the job.
CoreBSP 05.12.2017
In principle this clip is a great asset to the Ovid system. Alas its design has one basic flaw - the ability to get a really nice grip on the instrument - and the faff in getting it on and getting it to stay in place.

The basic flaw is in the design of the velcro fastening. The DPA clip has the velcro fixed at one end. The velcro comes through the clip and thus through a simple pull a very tight fit and secure fit can be achieved. I found that this clip was awkward (in so far as you need 2 hands holding bits of velcro in order to try to get the tension required - it just isnt as good - and in this case I have to say that despite its price you'll regret buying this - just get the DPA clip and enjoy life. You dont need to be cursing your equipment.
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
A
Does not really work in practice
Anonymní 09.10.2016
I bought this to amplify my flute live, using it to mount the t.bone CC100 microphone

Pros - none

Cons - lots...

It does not really work in practice.
The fixing tape is too long for a flute; I had to cut it.
The clip does not stay in place as it is too smooth - it just rotates round the body of the flute.
Wherever you install it the microphone and cable get in the way of the mouth piece.
The clip does not have any shock isolation, it picks up so much key noise from the flute which is clearly audible above the notes.
Very bad design.
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení